I'm following TI's C2000 GUI Composer tutorial to create a GUI composer project. On the first page of the New Project Wizard, I'm asked to upload "desktop shortcut icon" and "Window icon". The "Next" ...

I need to run debug on an old product. I have the tools and connectors used at the time development was done on it but cannot get the JTAG communication running. I'm using a MSP-FET430UIF (grey box) ...

设置SPI多个片选引脚除了config里面定义的其余引脚是否需要用GPIO虚拟，同时虚拟出来的引脚对传输速率是否有影响 可以使用GPIO模拟，在每次SPI发送之前，对SPI的片选信号也会进行控制，所以SPI的片选信号就是在每次需要发送到某个设备的时候，将CS片选端进行 ...

I think i have identified a discrepancy in the documentation of the MSTGENA field descriptions for the Memory Self-Test Controller Global Enable Key. This needs to be reviewed and corrected to align ...

I am trying to implement state machine based tasks in 28027. I referred some programmes given in control suite. I am however not able to go between various tasks A0, A1, A2 etc. What could be the ...

Hi I want to get an interrupt when a SPI reception finished. My setup is the following. I have an SPI D configured as master with loopback mode. My actual application will be configured as slave but ...

Understanding these aspects is crucial for our project and system stability. Any insights or additional documentation you could provide would be highly valuable. Thank you for your assistance.

I hope this message finds you well. I am currently in the process of selecting a microcontroller for a safety critical Class C medical device that we are developing, which will be using SafeRTOS. We ...

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

The customer's PD system uses the PMP41115 solution, and there is a reference design on the TI official website But there are a few issues that need to be confirmed, 1.Should the red X line in the ...

We have encountered a boot up issue with TDA4AL at -40 degree C. The boot up process hanged and cannot be recovered even we try to reset the PMIC power on process. The boot process kept the same ...

Using TL494 IC to do a boost converter . The input voltage is 100-250V, the output voltage is 300V, full load power is 250W. The switchin frequency is 300kHz. And this is my schematic And this is my ...