设置SPI多个片选引脚除了config里面定义的其余引脚是否需要用GPIO虚拟，同时虚拟出来的引脚对传输速率是否有影响 可以使用GPIO模拟，在每次SPI发送之前，对SPI的片选信号也会进行控制，所以SPI的片选信号就是在每次需要发送到某个设备的时候，将CS片选端进行 ...

I have some question s on the fueses. this is not only relates to TPS2HCS10-Q1, but in generakl for the HCS -Family. I have following questions: Standby - Active Mode of MCU eFuses must be active even ...

2)VIO pin required & supply voltage level is 3.3v 3)Should have CAN Signal improvement capability as per CiA-601-4 standard I am seeing the potential of TCAN1042-Q1. Will this work with the ...

My customer is using MSP-GANG as programming tool for LP-MSPM0G3507. they faced the issue when programming, see the status below. But they are able to program MCU with XDS110, so the MCU works well.

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

We are seeking assistance with a Flyback SMPS design using the UCC28750 controller. The design was based on the UCC28750EVM-071 User Guide and the UCC28750 Datasheet. At no load, the output reaches a ...

we have a microelectronic system which draws power from the REG1 configured to supply 3.3V when the battery pack is connected. However, when the battery pack is not connected, we will supply 3.3V from ...

i bought for my private study a launchxl-f28379D and launchxl-f280049C , i've never had an experience with that mcu's before . I'm using a CCS version 12.6.0.00008 on Win11 . I had a problem with ...

I want to add that Sysconfig gives an error that the base has been duplicated when I use two inputs from the same ADC. I expected the base to stay the same for a ...

1. Based on suggestion from this LM5190-Q1: CC-CV regulator design - Power management forum - Power management - TI E2E support forums , will this LM5177 Buck-Boost Controller work well for my ...

I'm not connected the Battery yet. Trying to power on the board using external power. So, I have powered my device using Type C cable from my laptop. And I got 8.6V in SYS1 & SYS2 pins. This is clear.

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will ...