I have some question s on the fueses. this is not only relates to TPS2HCS10-Q1, but in generakl for the HCS -Family. I have following questions: Standby - Active Mode of MCU eFuses must be active even ...

2)VIO pin required & supply voltage level is 3.3v 3)Should have CAN Signal improvement capability as per CiA-601-4 standard I am seeing the potential of TCAN1042-Q1. Will this work with the ...

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

Vin: I created a circuit that boots from 5V to 6.3V and converts it to 5V with a regulator, but when I connect a 100mA load, Vout drops to 5.3V. Can you catch a waveform of the unexpected Vout drop.

i bought for my private study a launchxl-f28379D and launchxl-f280049C , i've never had an experience with that mcu's before . I'm using a CCS version 12.6.0.00008 on Win11 . I had a problem with ...

We are seeking assistance with a Flyback SMPS design using the UCC28750 controller. The design was based on the UCC28750EVM-071 User Guide and the UCC28750 Datasheet. At no load, the output reaches a ...

1. Based on suggestion from this LM5190-Q1: CC-CV regulator design - Power management forum - Power management - TI E2E support forums , will this LM5177 Buck-Boost Controller work well for my ...

I'm not connected the Battery yet. Trying to power on the board using external power. So, I have powered my device using Type C cable from my laptop. And I got 8.6V in SYS1 & SYS2 pins. This is clear.

I want to add that Sysconfig gives an error that the base has been duplicated when I use two inputs from the same ADC. I expected the base to stay the same for a ...

I hope this message finds you well. I am currently in the process of selecting a microcontroller for a safety critical Class C medical device that we are developing, which will be using SafeRTOS. We ...

I am trying to implement state machine based tasks in 28027. I referred some programmes given in control suite. I am however not able to go between various tasks A0, A1, A2 etc. What could be the ...

We have encountered a boot up issue with TDA4AL at -40 degree C. The boot up process hanged and cannot be recovered even we try to reset the PMIC power on process. The boot process kept the same ...