I remember getting the parts in the mail. ... This was the only article on injection molded standoffs I’ve ever read. Report comment. Reply. Rob says: October 28, 2016 at 11:48 am ...

Injection molded toy parts with runners intact. Ejector pins are little pins that press the part out of the mold. Molds are designed so that every time they open the part will be stuck on the same ...

The first half of Going it Alone, Part III: Inside the Factory Walls appeared on CrunchGear yesterday. We pick up our survey of how consumer electronics are made with … “One Word: Plastics ...

Designing plastic parts that can be molded has always been important for traditional injection molding processes, but it’s particularly beneficial for parts about to be rapid injection molded ...

For thermoplastic injection molding, which is the most common process, the part cools and hardens in the mold. Traditional injection molds can withstand high temperatures so that processors can ...

While the components themselves are made of glass fiber-reinforced polyamide 6 (PA6), integration of four unidirectional (UD) carbon fiber tapes, which are placed into the mold during injection ...

Moldflow has released Version 5.0 of its Moldflow Plastics Advisers (MPA)software. The software, which is made up of the Moldflow Part Adviser and theMoldflow Mold Adviser, is designed to let plastic ...

SEKISUI CHEMICAL CO., LTD. (TOKYO:4204) (President and Representative Director: Keita Kato; "SEKISUI CHEMICAL") has decided ...

Founded in 1985, M.R. Mold employs 30 people who design and build molds almost exclusively for the medical market to manufacture components, such as valve caps for the pumping units of medical masks.